i have looked at my dyson and I can't see how to get the hose off of the machine. Please can you advise me on how to fit this. Thanks
- 09 October 2009
Haven't you had an answer yet, Ness? Grip one end, twist until it moves, then pull. Then the same at the other end.
By priorypete- Sussex
- 29 April 2010
you have to take bottom cover off the brush there are three plastic half turn bolts then push drive belt off at the motor shaft pull brush out with belt,pull brush cover with hose assembly out ,unscrew hose off screw new one on, put drive belt back on motor shaft ,refit brush cover and pull belt back though it, pull belt so you can push brush though it, re fit the brush,refit the bottom cover
By JOHNWITHDOT- lincolnshire
- 24 April 2010
Take the plate off the bottom. Use coin to turn screws. Prise off old hose where the push fit is, and unscrewother end. Replace push fit. In theorey you line up the plastic screwtube threads, and twist. One end of the pipe is a left hand thread, the other RH. In practice you need to juggle, but it will fit and screw home eventually. Then put everthing else back.
Required for another application. ( Bissel carpet washer)
By bramley60- Homecounties
- 20 November 2009
We do not usually put up measurements as our parts are model specific. This part is made specifically for the Dyson models listed above. Please check your model details to make sure you get the correct parts. The following link may help you: