If your fan oven is not heating up properly the usual culprit is a faulty oven element. This is a replacement spare so be sure to view the model fit list and check the specs, prior to purchase to ensure the spare is correct for you. Once fitted to your oven food can be cooked piping hot once again!
End to centre bracket 220mm
Compatible spare for select Stoves, Belling, Cannon, Creda, Hotpoint and Indesit ovens.
Please check the list of suitable models to ensure that this spare part will fit your appliance.
How to replace an oven element
This video should help with fitting this part. However, the exact layout and fitting technique may differ for your make and model.
Be safe - always unplug any appliance from the electricity supply before carrying out any work on it.
If you are in any doubt contact a qualified repairer.
QMy Old element is very difficult to get out there dosent seem to be screws attaching it ?1 Answer
- 10 February 2014
The element may be fitted using nuts from the back of the oven. Remove the back and locate where the element cones through the lining. carefully part the insulation and you may find the bolt shafts and nuts that hold the element in place.
QGot the oven element out no problem but I can't get the clips to stay on the new one, they keep slipping off. Do you have to tighten them, and if so, how?1 Answer
By Tara56- Glasgow
- 04 December 2013
We assume the 'clips' you refer to are the electrical connectors to the element. Remove them from the element and gently squeeze them with a pair of pliers and check they now fit tightly. If you accidentally crush them with too much force you will need to replace them. These connectors are available from Maplins or most car accessory stores.
Qrcd trips when fan in oven is about to start1 Answer
Creda Hotpoint electric oven. Almost every time we use our oven the RCD for the cooker trips as the fan is about to start. This has happened for at least 6 months now. Element used is 2500w as above bought Dec 2010. Any asiistance on how to resolve this very welcome. thanks.
By Steve- Seaton, Cumbria
- 09 November 2011
If this has only been the case since you replaced the element are you sure that the wires have gone back in the correct place and are not touching the retaining screw or someother metal part of the cooker.
my element is from an ariston cooker 250mm across connectors 50mm apart 2500 watt exact image of above. nothing in ariston looks anything like mine.
By sark- ashford kent
- 25 June 2011
The ring is about 250mm diameter. The fixing plate is just inside the element ring. The fixing plate is about 25mm x 60mm with a central fixing hole. The element passes through the fixing plate at 40mm centres.