Bosch Dishwasher Dispenser Tripping Device with Spring for SGS57E18GB/36 Stock Number: ES546388

Overall rating

• Anonymous Castle Donington
  5.0 out of 5

  30 min puzzle, one minute job 12 June 2009

  For some time the lid had been partially popping off the guides during the detergent release cycle. Then one day it popped off completely - I found the spring and the lid in the bottom of the dishwasher. On the assumption that I would have to spend £150 getting a repairman with complete new soapdish assembly, we manually added the soap tablet after the 15 minutes rinse cycle. This went on for two years! Until, on browsing Epares and the very helpful reviews I saw that the soapdish lid and the spring could be bought as spares. Fitting the lid and the spring requires 30 minutes working it out time and one minute fitting time. There is only one way the spring can fit but it is quite a challenge to select the right way from the multiple choice. When you have done this, press on the soapdish end of the spring - it squeezes on over the soft plastic. Then offer the lid/spring assembly to the dish and pop the other end of the spring into place. Then you have to spreadeagle the sides of the lid a bit to force the lid guide spigots over a lip and into their guide grooves. It's a one minute job but allocate an undisturbed 30 minutes because the spring is a bit of a brain-teaser and the lid, too, until you realize that it has to be forced into place. Delivery was a week or so longer than quoted at time of purchase.

  Quality	5.0 out of 5
  Value	5.0 out of 5
  Ease of fitting	2.0 out of 5

• bouldcarol wrexham
  5.0 out of 5

  easy to install 07 May 2009

  i have recently had a new dishwasher tripping device spring and it was very easy to install, i would have sent for one sooner had i known this and it was cheap to buy as well.

  Quality	5.0 out of 5
  Value	5.0 out of 5
  Ease of fitting	5.0 out of 5

• CheapskateIan Southampton
  5.0 out of 5

  Perfect replacement part 24 January 2009

  Again I only need the spring (seems this is a major weakness in all dishwashers). It is fairly easy to fit and I suggest clip the spring to the main unit then slide the cover (front lugs only in slot) towards the spring so you can clip the other side of the spring to the cover (tip the cover up to help). Gently pull the cover back until the rear lugs can be engaged in the slots. Good quality service from espare, emailed me to say initially out of stock but delivered well before the expected delivery date. Saved a lot of money and highly recommended.

  Quality	5.0 out of 5
  Value	4.0 out of 5
  Ease of fitting	4.0 out of 5

• PaulUKC Surrey
  3.0 out of 5

  Exactly as expected 23 October 2008

  Components where exactly what I expected. I only needed the spring - so the rest was redundant for my purposes. Fitting was a little fiddly but done in a few minutes.

  Quality	3.0 out of 5
  Value	2.0 out of 5
  Ease of fitting	3.0 out of 5

Ratings-Only Reviews