Universal 4-Sided Oven Door Seal (For Rounded Corners) Stock Number: ES1712443

Overall rating

• Steve bendell Cwmbran
  4.0 out of 5

  Worked fine 05 May 2017

  This kit worked fine on my Baumatic oven with rounded corners, now have an oven that heats up and stays hot

  Ease of fitting	4.0 out of 5
  Quality	4.0 out of 5
  Value	4.0 out of 5

• P White Shrewsbury
  4.0 out of 5

  Good, well fitting replacement oven seal 28 April 2017

  Easy to fit, comprehensive instructions, a good quality door seal

  Ease of fitting	4.0 out of 5
  Quality	4.0 out of 5
  Value	4.0 out of 5

• ploughboy
  4.0 out of 5

  Good purchase 22 March 2017

  A good substitute for and good value compared to the manufacturer's part despite large price increase since 2014.

  Ease of fitting	5.0 out of 5
  Quality	5.0 out of 5
  Value	4.0 out of 5

• JGC BATH
  4.0 out of 5

  easy to fit and does the job 18 October 2016

  sounds obvious but easy to make a mistake: make sure you insert the cornergrips with the hook on the back face which goes flat against the oven face, because once they are in, the only way out is to cut the rubber!

  Ease of fitting	4.0 out of 5
  Quality	4.0 out of 5
  Value	4.0 out of 5

• T. Shilling Essex
  4.0 out of 5

  Product replacement Door seal for oven 04 August 2016

  Door seal had stretched and drooped. New seal purchased, arrived promptly. Was easy and quick to fit, appears to be working well so far.

  Ease of fitting	5.0 out of 5
  Quality	3.0 out of 5
  Value	3.0 out of 5

• Col South Wales
  4.0 out of 5

  Seems good quality. 09 June 2016

  Easy to fit but had to trim the front part of seal off because oven door wouldn't shut properly. It was easy to trim with very sharp knife. Working great now.

  Ease of fitting	5.0 out of 5
  Quality	4.0 out of 5
  Value	4.0 out of 5

• J W H Orpington
  4.0 out of 5

  A bit tricky for my ancient oven 14 April 2016

  This seal being the only one on the market, I decided to go for it as my old AEG COMPETENCE 5210V one with rounded corners was perishing and had been stapled together for a while. My original seal was fairly flat and on receipt of the new one I realised immediately that it would be too thick. The other issue was that the new metal plates had the hooks at the top, whereas my old ones were near the bottom of the flat side of the seal. I set about modifying the new seal. I removed and cleaned the old plates from their seal and after cutting the new one to size, I inserted both the new and the old. My old plates did not have the jagged teeth and were somewhat shorter and thinner so they needed the new plates behind them for stability. The cavity was large enough to accommodate both plates. I then bent the new hooks away from the seal but left them in. I then cut the top triangular part off all along the new seal. The new seal with the old plates with hooks in right position now fitted perfectly and the door closes onto the seal with a snug fit. A bit of a labour of love but totally worth it. I have photographs of the procedure if anyone needs them.

  Ease of fitting	4.0 out of 5
  Quality	5.0 out of 5
  Value	5.0 out of 5