Candy Tumble Dryer Heater Element Irca S 9276 845 - 2100W Stock Number: ES956282
Genuine spare part for select models of Hoover, Candy and Maytag tumble dryers
Candy GOC58F replacement heater element
- Actually there is a much simpler way to do this and it saves time too! It means just take off back panel over heater then carefully thread some strong sewing thread through the sides of the plastic rivet. Make sure you have strong thread and make loops about 20cm long. Then when you gently remove the plastic rivet the thread stays attched. Pull the connectors though and change one by one as before. Now carefully move the cotten loops to the new plastic rivet and gently pull on the loops. as you guide the cable back in. The thread will guide the rivet back into place and pull firmly to secure the rivet. Reassemble as before. Job done!!!!
-
Chris at eSpares says...
You will need to remove the following, Lid, control panel, lower front, door and seal, fan grill, fan, fan cover. Then reach through from the front to locate the clip. We have just videoed this repair and will have this in our advice centre and Youtube shortly.
My Candy o Comfort GCC590NB Condenser tumbler is not heating and after a few minutes stops and all lights on the front flash? Any ideas please
-
eSpares Staff at eSpares says...
You will need to test the element with a multimeter to confirm if it has failed.
-
Chris at eSpares says...
For information to diagnose your problem see our video: How to Diagnose Tumble Drier Drying and Heating Problems: www.espares.co.uk/advice/9/2050
Hotpoint Ultima Wash and dry 5 +5kg Model 31135R Serial no. 703210192 Please help.
-
Chris at eSpares says...
You can download a copy of the manual using the address below. http://www.espares.co.uk/usermanual/download?userManualId=3a6e0e45-c295-4e40-92b9-a57e009eb063
I have a Hoover VHC681B tumble dryer and it will not start. The start/pause light flashes, but the machine will not run 1 Answer
I replaced the heat element with a spare from eSpares at the end of October 2015 and gave the machine a good clean. The machine worked great until now...
-
Chris at eSpares says...
If when freshly plugged in the light changes when you first press the button then the control panel recognises the press. If this is the case check the door lock.
Hi my Hoover VHC681B was operating but didn't heat up then stopped with all warning lights flashing which indicated that I needed to change the heating element C/W thermostats, I ordered the replacement heater from you and installed it after also giving the drier a good clean (condenser element etc.) The new heater worked no problem but now less that a week later I have the same problem. Am I just unlucky enough to have a faulty heater element or is it something else, how do I test the heater element?
-
Chris at eSpares says...
Switching straight off stopping the circulation fan immediately when the element is heating can cause overheating and damage the element as the circulating air stops. Always allow the appliance to finish a cycle or select 'cool down' or 'cool cycle' to remove heat around the element before stopping.
It is a Hoover VHC180-80 condenser tumble dryer The serial number is 3110023609048647
-
Chris at eSpares says...
Sorry we do not have a video yet but to reach the heater connections you will have to remove the top, front and the drum assembly.
Hoover VCH681b-80
-
Chris at eSpares says...
There are two 'thermostats' fitted and supplied with this heater assembly.
Hoover vac 680c. Need to replace the heter element. How do I get to the internal connections 1 Answer
-
Chris at eSpares says...
Unfortunately to do this it is necessary to dismantle and remove the drum to access the connections on your model.
The instructions tell me to "clean the filter" !!! This has been done many times but still no heat. I have been told that it is possibly the heater element. Is there anyway of testing the old element just to make sure?
-
Chris at eSpares says...
For information to diagnose your problem see our video: How to Diagnose Tumble Drier Drying and Heating Problems http://www.espares.co.uk/advice/9/2050/how-to-diagnose-tumble-drier-drying-and-heating-problems
Will this part fit my appliance?
Check Now