Get The App From Play Store!

Skip to main content

Dishwasher Cold Water Single Inlet Solenoid Valve Stock Number: ES571337

Genuine spare part for select models of AEG, Zanussi and many more brands of dishwashers

Product Q&A

Ask a Question
By A Caton - WA8 9pb - 30 November 2019
  • eSpares Staff from eSpares
    eSpares Staff at eSpares says...

    The most likely reason would be the valve has weakened and is letting in water so check the valve.

Answer this question
By Dai Rees - Cardigan - 24 August 2018
  • eSpares Staff from eSpares
    eSpares Staff at eSpares says...

    Error code I30 on a Zanussi dishwasher refers to a water leak in the base activating the float switch, you will need to find where the leak is coming from.

Answer this question

Hi, I have trouble determing if my fill valve is dead or not. When I measure the resistance I get value of 4,3 kilo-ohms. What is the resistance of a new part?

By TT - - 03 February 2017
  • Chris from eSpares
    Chris at eSpares says...

    The resistance reading you quote is typical for this type of valve.

Answer this question
By Denny Chambers - Hampshire - 21 November 2015
  • Chris from eSpares
    Chris at eSpares says...

    For information to diagnose your problem see our video: How to Diagnose Draining and Motor Problems in a dishwasher: www.espares.co.uk/advice/3/1889

Answer this question

Will not fill but if I tip the dishwasher forwards, then it WILL fill. When I stand the dishwasher level again it goes dead (stops filling and doesn't do anything else either). An engineer did come and look at it, and said the fill valve was OK so he's not sure what the problem is - do you think I should go ahead and change the valve anyway, or could it be something different? Will very much appreciate any help. Many thanks,

By Anonymous - - 22 February 2011
  • Rory from eSpares
    Rory at eSpares says...

    Hi there, I'd advise checking the drainage system - it could be that there's a blockage there. The drainage system is situated in the base of the dishwasher; remove the lower basket - you should then see the drain sieve and drain filter.

Answer this question

On the water level switch or possibly the air/vacuum switch, it is about 5cms round with two adjustors - do I screw these in or out to adjust the water level - at the moment it is overfilling and flooding out onto floor.

By Anonymous - - 02 December 2010
Answer this question

Will this part fit my appliance?

Check Now

Dishwasher Cold Water Single Inlet Solenoid Valve

£25.70
(inc. VAT)
£25.70