Ariston Washing Machine Drum Paddle for AL12UK Stock Number: ES186730
Genuine spare part for select models of Indesit and Hotpoint washing machines
All three paddles have broken off my Indesit WIL133UK at the same time. Any suggestions why this may have happened? 3 Answers
- I was told a bra wire can do this or a 50p.
- Going to be a bit late with this answer I think but when it happened to my machine it was an Allen Key swirling about at the back of the drum that was shearing off the plastic clips that hold the paddles in place!
-
eSparesMalindi at eSpares says...
Sorry we don't diagnose faults, only replace the spare parts. Should you need technical assistance, please speak to an engineer.
I have tried fitting replacements but there is a metal piece in the centre that when upright prevents the paddles from sliding/cliping into place. If I bend this piece down and flush with the drum then the paddles slide/clip perfectly into place, however when I use the machine the paddles are not held securely and snap off (again!). I now need to order more of these but need to know how I get them to hold in place after fitting - i.e. how do I get the metal piece in position to hold them?
- I used a short length of thin string to lift the metal tab back up after fitting the paddle. Before fitting I bent the tab flush with the drum. I then looped the string around the tab (no knots) and fed the loose ends through a hole in the paddle. The paddle was pushed into place and then gripping both ends of the string I pulled the tab back up. The string was then removed by pulling one loose end.
-
eSparesMalindi at eSpares says...
We do have a help video for fitting this part but cannot advise beyond this unfortunately. If you require further assistance please contact an engineer for fitting this part. http://www.espares.co.uk/advice/washing-machines/a/7/1270/how-to-fit-a-washing-machine-drum-paddle.html
Could you please state somewhere that your instructional video does not relate to 12 hole paddle where the metal tab is below the 6th hole (not the 3rd)
-
eSpares Staff at eSpares says...
Thank you for providing the information regarding our video.
Drum paddles snapped yesterday then I put a wash on without them it fills with water spins a bit but if it stops where they have snapped it can't get going again
-
Chris at eSpares says...
Small plastic bits may have washed into the pump preventing it turning. See our video: How to diagnose washing machine drain and pump problems: www.espares.co.uk/advice/7/1732
I received the paddle I ordered for my Hotpoint washing machine very promptly. We have looked at your video how to remove and fit new paddle, but we are unable to remove the broken one. Help!!!
-
Chris at eSpares says...
The paddle is prevented from accidently coming off by the metal 'spring or flap' on the drum shown here: https://youtu.be/V-kIP83a4RU?t=49s this will stop the paddle from being removed until it is pushed down enough to clear the paddle.
I have an Indesit WD12X and one of the drum paddles just came off. Just wondered if it is easy to fit the new one and if I could get instructions? 1 Answer
- My model number is different but if fitting is the same you place the paddles over the grooves in the drum then push forward or back into the narrow section of the grooves and the paddles are secure quite literally a minutes job.
wf561puk washing machine paddle has a hole in it but i cant work out how it comes off to fit the new one i have just ordered, any suggestions.
- It should just slide towards you. It may be a bit stuck as they are tight fitting but it will slide towards you with a bit of effort then the new one simply slides back onto the metal slots. Hope this helps.
I have an Ariston AMLG 101 (Washer/dryer). Will this drum paddle fit my machine??? thanks,
-
Rory at eSpares says...
Hi Vals, I'm afraid I can't match your model number in our washing machine or tumble dryer databases. Would it be possible to double check? For help locating it, use our guide: http://www.espares.co.uk/findingmodelnumbers.aspx#a7
i have a paddle the same spec but different in size. can you advise me the number for a paddle 186mm full length. 1 Answer
i have a paddle the same spec but different in size. can you advise me the number for a paddle 186mm full length.
-
Rory at eSpares says...
Hi Mrturner, there's a lot of paddles that are 186mm long - I'll need your machine's model number to find you the right one. For help locating it, use our guide: http://www.espares.co.uk/findingmodelnumbers.aspx#a7
I have an INDESIT WASHING MACHINE - MODEL NO.WIXL 163 S. Could you tell me if you have a washing machine drum paddle to fit this type of washer, please?
-
Rory at eSpares says...
Hi Lush, this paddle will fit your machine.
Will this part fit my appliance?
Check Now