Kenwood Dishwasher Thermostat for KDW12ST3A Stock Number: ES1560613
Genuine spare for select Kenwood and Matsui dishwashers
Dishwasher showed error code E3, replaced the thermostat and no longer have error code however, the cycle stops at 1 hour 6 mins on the eco cycle and and dishwasher just displays the time remaining. It pauses on all cycles. Any suggestions on the issue? 1 Answer
-
Dean at eSpares says...
Examine the control board for signs of burning or poor connections on the relay, There may be a 'dry joint' on the heater relay on the control board. Also, see our diagnosing video for help www.youtube.com/watch?v=7b1-M_WKYJs&t=35s just copy and paste into your browser.
i have fitted a new through heater to dishwasher still no hot water need to know if overheat stat needs replaceing 1 Answer
-
Chris at eSpares says...
For information on this problem see our diagnosis video: How to Diagnose Dishwasher leaking and heating problems www.espares.co.uk/advice/3/2083
Hi. What is the resistance of the thermostat when it is good. I have just took it out of the machine and what I can measure is more than 8kohm. I am trying to identify the problem.
-
Chris at eSpares says...
We believe this is a simple thermostatic switch that should measure short circuit.
Dishwasher will work fine until occasional E3 fault. Dishes are not rinsed and are cool whenever this fault occurrs. What would you suggest?
-
Chris at eSpares says...
Error E3 refers to a heating problem. check the thermostat below the heater on the outside of the tub is in good contact with the tub skin and not loose. Also examine the control board for signs of burning or poor connections on the relay.
hi I changed the thermostat on my kenwood kdw12sl3a ,and the e3 error code sometimes comes on and it dosent finish the rinse cycle ,and they are not always hot either
-
Chris at eSpares says...
There may be a 'dry joint' on the heater relay on the control board that will allow the heater to work sometimes. Check and replace if the control board if required.
have just bought and fitted a heating element and the dishwasher still does not work
-
Chris at eSpares says...
This fault could be due to the heater element (already changed) . Its thermostat or cut out (normally short circuit when ok), or a fault with the control board or wiring loom.
Will this part fit my appliance?
Check Now