Skip to main content

Call 0844 9777 888 (7p per min + any network access charge)

Universal Cooker Hood Filter Kit Stock Number: ES131936

High quality replacement spare for 60cm cooker hood models

Product Q&A

Ask a Question

I have a Hotpoint HTN40 Cooker hood

By Ali - Cheltenham - 08 September 2010
  • you dont need carbon with a cooker hood that extracts to the outside. You only need a carbon when you have a recirculating cooker hood. e.g. do you have a grill on the outside of the kitchen wall for the fan? By Russell - cumbria - 21 July 2015
  • Yes I always put both filters in together. When you have a fry up for the family check the filters - these are cheap enough to change before they get too blocked. By Trisha T - Clacton on Sea - 30 July 2013
  • I would say yes, our cooker hood came with both installed. By Bomber - Oxfordshire - 16 November 2010
Answer this question
By Carol Robinson - Bristol - 10 September 2019
  • Parminder from eSpares
    Parminder at eSpares says...

    The charcoal filter is not recommended to be washed but replaced when saturated.

Answer this question
By LR - Bucks - 12 March 2019
  • eSpares Staff from eSpares
    eSpares Staff at eSpares says...

    If your cooker hood is recirculating back into the room you do need a carbon filter.

Answer this question

I purchased a universal cooker hood filter in foam and charcoal. However on removing the old filter there was also a paper filter. I've now sent for the paper one as well. Is this ok to use all three? Ie. Paper first then foam and finally carbon. Thanks.

By Agnes Buggy - Carluke - 09 October 2017
  • Dean from eSpares
    Dean at eSpares says...

    The paper filters are designed for grease and the foam filter is for absorbing the smells, you would not normally use all 3 so check your user guide for your model to be sure as it depends on whether the hood is venting outside or recirculating.

Answer this question
By Paula Singleton - Eastbourne - 05 April 2016
  • Chris from eSpares
    Chris at eSpares says...

    The paper filters are designed for grease and the foam filter is for absorbing the smells. Not using the grease filter would quickly saturate the foam filter and reduce its efficiency at removing odours from the air.

Answer this question
By J SMITH - United Kingdom - 05 November 2015
  • Chris from eSpares
    Chris at eSpares says...

    We think the stripes go inside and show through when replacement is required.

Answer this question
By Tony - Lancashire - 12 July 2015
  • Chris from eSpares
    Chris at eSpares says...

    If your hood is recycling the air instead of venting outside then it should have carbon filters attached to the motor. It would be more effective to replace these than trying to fit this filter as your appliance is not likely to be designed for this.

Answer this question
By R. F. - Lancashire - 06 March 2015
  • Chris from eSpares
    Chris at eSpares says...

    These filters can be cut to size and used in many extractors.

Answer this question

Are there supposed to be clips or do they simply sit on the 2 Frames.

By Pedro - Devon - 22 July 2014
  • Chris from eSpares
    Chris at eSpares says...

    This type of filter is used in cooker hoods as shown in the How to Video. If your hood uses a metal panel grease filter this product is not suitable.

Answer this question
By Anonymous - scotland - 21 November 2013
  • Chris from eSpares
    Chris at eSpares says...

    It does not matter but if you can see from under the hood it is easier to know when you should change it.

Answer this question