Get The App From Play Store!

Skip to main content

Tumble Dryer Bearing Flange Stock Number: ES625824

Genuine spare part for select models of Acec, AEG and many more brands of tumble dryers

Read more

Manufactured by Electrolux

(This part fits select models)

Will this part fit my Appliance?

Does it fit?
Enter your model number and select from the below list
Need help finding your appliance model number?

Check this part fits your appliance

2. Enter your model number

Tumble Dryer Bearing Flange

Bearings are an essential to any appliance that was originally fitted with them, so time to replace yours. This bearing flange is practically the rear bearing, so old and worn ones will make your machine sound like a rattle and probably cause some damage.

This is a genuine Electrolux spare part that has been made to fit over 20 brands and models of dishwasher.

Please remember to check in the model fit list to see if it will be compatible with your appliance. 

Ask a Question

3 Questions and 3 Answers

Also when i took the small plastic cover off the bearing there was, what looked like iron filings there. the fan belt has not snapped, thats still round the drum

By Pam - Liverpool - 22 July 2015
  • Chris from eSpares
    Chris at eSpares says...

    The 'iron filings' suggest a worn bearing but if it has cut through the drum spindle it would stop the drum from moving.

Answer this question

the drum on the dryer can be lifted at the front and the drum needs a push to start, if i change the bearing flange on the back will i need to change the front bearings and are they felt?

By big al - bolton - 07 October 2013
  • Chris from eSpares
    Chris at eSpares says...

    The drum on a tumble drier is sealed by the felt and rests on rollers to support it. The most likely cause of this problem is the motor capacitor Stock Number: ES625752. These capacitors fail and cannot give the power to start the drum turning when loaded but may once spun be able to continue the rotation.

Answer this question

my Lux tumble dryer WT60, The bearing flange just stuck with the drum shaft after the 3 nuts and retaining clip and washer were removed, the drum can be turned normally but I can't withdraw or separate the drum from the rear panel. i wonder do i need special tools? or just drive the shaft with soft hammer?

By Ting Champ - Thailand - 18 August 2013
  • It's ok now when i had a good look (with magnificent len) at the edge of the drum shaft i found it's a bit rusted and not smooth. so i used sand paper to rust out then it came out easily. Thank you for espares.co.uk By Ting Champ - Thailand - 19 August 2013
Answer this question

Will this part fit my appliance?

Check Now

Tumble Dryer Bearing Flange

£20.46
(inc. VAT)
£20.46