Zanussi Washing Machine Rubber Door Seal for ADV106

Fits the following models [?]

Click on your brand to see the model numbers this part fits.

How to replace a washing machine door seal

This video should help with fitting this part. However, the exact layout and fitting technique may differ for your make and model.

Be safe - always unplug any appliance from the electricity supply before carrying out any work on it.
If you are in any doubt contact a qualified repairer.

• Fast delivery, fitting it though.... 25 October 2012

  • Overall Rating 5.0 out of 5
  • Ease of fitting 3.0 out of 5
  • Quality 5.0 out of 5
  • Value 4.0 out of 5

  By Steve - Kent

  Took nearly an hour (didn't remove door as it wasn't really a hindrance), the main problem was getting the inner seal on properly and the retaining spring which required an extra pair of hands provided by my wife. Could have been worse though and at least it doesn't leak.

• There must be an easier way. 09 May 2012

  • Overall Rating 4.0 out of 5
  • Ease of fitting 3.0 out of 5
  • Quality 5.0 out of 5
  • Value 4.0 out of 5

  By Anonymous - Southampton

  You don't need to take off the top of the machine, just remove the door. You need Star bits to do it. The old gasket is held in with a plastic securing ring around the outside that was fiddly to remove; 2 small screwdrivers to prise apart the locking teeth did it. The gasket the pulls out through the front hole to reveal a large circular spring that is for holding the gasket to the inner frame so don't lose it! Fitting the inner seal is hard but made easier if you smear a little washing up liquid round the rubber. NOT too much or you won't be able to hold it!! Once that is on you now need to refit that circular spring. Having only one pair of hands I had to use about 4 mini g-clamps to hold it in place as I stretched it round. That done the Gasket is fitted to the outer casing and the plastice retainer needs refitting. Use the little screwdrivers again to close it up tight.3 broken finger nails, a bruised thumb much cussing and 2 hours later the machine was back together and now runs like a dream with no leaks. I'm sure Mr Zanussi has an easier way to do it. However, it was well worth it to save on the cost of a new machine or for a "repairman" to come out. Thanks espares... I'll be back!

• Video could be misleading- check your model 19 March 2012

  • Overall Rating 3.0 out of 5
  • Ease of fitting 1.0 out of 5
  • Quality 4.0 out of 5
  • Value 3.0 out of 5

  By JC - Torquay

  Product was good, but fitting was not as shown in the video. Tricty Bendix model did not have a removable front panel so access was tight and took about 20mins to fit.

Read all reviews...