Zanussi Tumble Dryer Bearing Flange Stock Number: ES625824
Genuine spare part for select models of Acec, AEG and many more brands of tumble dryers
Manufactured by Electrolux
(This part fits select Zanussi models)
Will this part fit my Appliance?
Check this part fits your appliance
Tumble Dryer Bearing Flange
Bearings are an essential to any appliance that was originally fitted with them, so time to replace yours. This bearing flange is practically the rear bearing, so old and worn ones will make your machine sound like a rattle and probably cause some damage.
This is a genuine Electrolux spare part that has been made to fit over 20 brands and models of dishwasher.
Please remember to check in the model fit list to see if it will be compatible with your appliance.
3 Questions and 3 Answers
Also when i took the small plastic cover off the bearing there was, what looked like iron filings there. the fan belt has not snapped, thats still round the drum
-
Chris at eSpares says...
The 'iron filings' suggest a worn bearing but if it has cut through the drum spindle it would stop the drum from moving.
the drum on the dryer can be lifted at the front and the drum needs a push to start, if i change the bearing flange on the back will i need to change the front bearings and are they felt?
-
Chris at eSpares says...
The drum on a tumble drier is sealed by the felt and rests on rollers to support it. The most likely cause of this problem is the motor capacitor Stock Number: ES625752. These capacitors fail and cannot give the power to start the drum turning when loaded but may once spun be able to continue the rotation.
my Lux tumble dryer WT60, The bearing flange just stuck with the drum shaft after the 3 nuts and retaining clip and washer were removed, the drum can be turned normally but I can't withdraw or separate the drum from the rear panel. i wonder do i need special tools? or just drive the shaft with soft hammer?
- It's ok now when i had a good look (with magnificent len) at the edge of the drum shaft i found it's a bit rusted and not smooth. so i used sand paper to rust out then it came out easily. Thank you for espares.co.uk
Will this part fit my appliance?
Check Now
