Universal Permanent Round Wall Tumble Dryer Vent Kit Stock Number: ES503439
Particularly suitable for houses built of stone or cement rendered.
Will this part fit my Appliance?
This product is compatible with:
- Tumble Dryers except gas tumble dryers
Universal Permanent Round Wall Tumble Dryer Vent Kit
This vent kit is easy to fit and works with most tumble dryers except gas dryers. If your house is built of stone or is cement rendered a core drill is required for installation.
Kit includes:
- 1 x Hose End 100mm to 80mm (4" to3")
- 1 x Flange
- 1 x Screw Packet containing 3 Nylon Studs, 8 screws 8 raw plugs all in a resalable bag
- 1 x Round Gasket
- 1 x 100mm x 1 mtr PVC flexible hose
- 1 x Threaded Hose Connector
- 1 x Round Wall Plate
- 1 x Telescopic Tube 175mm-350mm
- 1 x Gravity Wall Outlet.
- Suitable for: Universal
Please note: this kit is not suitable for gas tumble dryers.
6 Questions and 6 Answers
what diameter hole in the wall is required to fit the kit? I can hire a drill with a 107mm bit. Will this do? 1 Answer
-
Chris at eSpares says...
The core drill you are looking at should be the correct size for the wall vent.
-
Chris at eSpares says...
If your dryer on its exhaust outlet has a plastic connector with a screw thread on its inside to take the four inch/100 mm hose (we think it has). then yes this is all you may need.
Will this kit fit my Servis M200W-1 tumble dryer, do I need the additional servis hose bayonet joint adaptor ES140726 1 Answer
-
Chris at eSpares says...
It is likely that you will need the adaptor ring as well as this kit unless you already have a hose attached to your machine.
the type is tm 220W any help please thank you gilly.
-
Chris at eSpares says...
This is a 'universal kit, that is suitable for many appliances that use a 100mm duct. Your hood if it has a connecting spigot can couple onto it directly, If not it would have to be adapted to connect.
To elaborate: I wish to vent the dryer through a brick wall. I want the dryer to sit under a work surface and front flush with other units, the dryer's venting outlet would thus be very close to the wall, I'd want to create the hole it the wall directly aligned to the dryer's vent and then semi-permanently install the dryer almost "plugged-in" to the kit's internal apature
-
Matt36 at eSpares says...
Hi GeorgeT, unfortunately I'm not nearly enough qualified to help you with your problem. I advise you ask a specialist on the subject before purchase.
