Karcher Pressure Washer Inlet Elbow Assembly - Version 1 Stock Number: ES538422
Genuine spare part for select Karcher pressure washers
your video on how to fit shows the engineer removing a clip. This clip is not on my washer a K3.99M, how do I fit the assembly
- I cannot find the release clip for the Inlet Elbow on my K4.99, do I need to try something else?
-
Rory at eSpares says...
Hi bert, the inlet fits in the same was as the video above, but rather than a clamp holding it in to place, the cover acts as the clamp.
for a karcher K3.99M (1.423-245.0)
-
Dean at eSpares says...
You will need to split the casing, here is a video to help www.youtube.com/watch?v=qsa9DrI5szI&t just copy and paste into your browser.
-
Chris at eSpares says...
There should be information on the ratings label. This part is suitable for a K3.90 model
-
Parminder at eSpares says...
We believe a torx kit will be required. Please see the link below for our "9 Piece Torx Head Screwdriver Set", www.espares.co.uk/product/es1251179
Looks like the part that broke on mine. Serial no. is 291975.
-
Chris at eSpares says...
To source the exact part you require please provide us with the following information: Appliance make, model and serial number of your appliance. For further help visit the "Finding Model Numbers" page on our website here: http://www.espares.co.uk/findingmodelnumbers. Alternatively please copy and paste this link into your web browser.
-
Kas at eSpares says...
Hi, Here is a short video on our website showing how to remove the Inlet and Outlet Connector on a Karcher 3 series. However the process should be fairly similar.
I have a K2 pressure washer, but the thread on joint where I attach karcher hose has worn away and it keeps jumping off! Help! Which part do I need to replace it please! Model 1.673 - 224
-
Chris at eSpares says...
You need to replace either the hose or the elbow depending on where the damage is. See the video on this part.
This part does not fit although your website says it is the right part. The video you show to install it shows the actual identical correct part which is slightly different from the one you supplied.
-
Chris at eSpares says...
There is two production versions of the K3.99, one uses this part and the other uses Stock Number: ES953411
Hi I need to get a inlet elbow for my old karcher 320 your inlet are all black and the one on my pressure washer is clear plastic
-
Chris at eSpares says...
It may be that Karcher have changed the plastic in production and the clear is no longer available. If the part is listed for your appliance the colour of the plastic is not likely to be important.
my jet wash sounds like it is just ticking over and has no power, its like its reving on and off on its own 1 Answer
i notice that there is water leaking from the inlet piece on the bottom of the machine, from when i pulled it over on to its side by mistake. i did strip it like the video i seen that this elbow is cracked also just behind where it sits is cracked any ideas need help bad
- I had the same problem and the only solution is to replace the inlet pipe. However I have discovered that the original pipe is no longer available. I have botched the fitting with silicon tape which minimises the leak.
Will this part fit my appliance?
Check Now