Bosch Lamp Cover Remover Tool

Fits the following models

All Bosch Cookers & Hobs, Neff Cookers & Hobs and Siemens Cookers & Hobs.

• Super little tool 19 May 2013

  • Overall Rating 5.0 out of 5
  • Ease of fitting 5.0 out of 5
  • Quality 5.0 out of 5
  • Value 5.0 out of 5

  By GrannyGill - Winsford

  Don't even try to remove the glass cover over your oven light without this little tool. It fits snugly over the glass cover to give you a handle to grip whilst turning, making removal quick and easy. It's a must have piece of equipment. I have no hesitation when I say buy this - you won't regret your purchase.

• Great little tool 13 May 2013

  • Overall Rating 5.0 out of 5
  • Ease of fitting 5.0 out of 5
  • Quality 5.0 out of 5
  • Value 4.0 out of 5

  By Bramley107

  On one hand, a bit pricy for a piece of plastic. On the other hand, a lot cheaper than calling out an electrician or losing an afternoon to take the oven out to get in behind. I took a moment to work out which was anti-clockwise, which played with my mind as I was looking at the roof of the oven, and then gave it a twist - done! I might have been helped by the oven having some residual heat from being on earlier in the day. Great little tool, just hope I remember where it is when I need it next!

• Saved my Bacon 02 May 2013

  • Overall Rating 5.0 out of 5
  • Ease of fitting 5.0 out of 5
  • Quality 5.0 out of 5
  • Value 5.0 out of 5

  By Porky - Angus

  After struggling for ages to get the light cover off I decided to seek help. Came across this site on the web and found the precise tool I needed. Cover came off within seconds. Great!

Read all reviews...

• Q How do I get bulb cover off even with the gadget just purchased 2 Answers

  The Lamp Cover remover tool has just been delivered. Neither of us are able to turn it and remove cover. Is there a technique/trick to this? Thank you.

  By Gadgetmad - Reading - 15 December 2012

  • A

    Hi Gadgetmad. When the oven is cold, Play the hot air from a hair dryer over the glass surface for a few minutes. Start off on a low heat first. This should expand the glass cover a little to release the bond. This tip is a bit late as I have just seen your post.

    By Joseph - 25 February 2013

  • A

    I just bought one of these gizmos before Xmas and it did the trick immediately. No messing. Worked first time. You have to line up the 'fins' on the glass cover to the recesses in the gizmo. It is quite a secure fit when you get it on. It should just slide on and a sharp twist ANTI clockwise should do it. Make sure you are turning it to the left as you look at the light. Perhaps the glass housing is stuck on with oven / cooking deposits? Try some oven cleaner to free it perhaps? Good luck.

    By Anonymous - Somerset - 08 January 2013

  Answer this question