Fits the following models [?]

Click on your brand to see the model numbers this part fits.

• Electrolux Vacuum Cleaners (37)
• Zanussi Vacuum Cleaners (3)

Description

How to replace an Electrolux vacuum belt

This video should help with fitting this part. However, the exact layout and fitting technique may differ for your make and model.

Be safe - always unplug any appliance from the electricity supply before carrying out any work on it.
If you are in any doubt contact a qualified repairer.

More product images

Product Reviews

4.8/5.0 Rated 4.8 out of 5 (240182 customer ratings)

• 13 May 2013
  • Overall Rating 1.0/5.0
  • Quality 1.0/5.0
  • Value 1.0/5.0
  • Ease of fitting 5.0/5.0

  By Rusty - kent - Fix-It Expert

  I have found that the belts break very easily, as I have had to order four in the last few weeks, as well as using the two that came with the machine.

• As usual superb

  02 May 2013
  • Overall Rating 5.0/5.0
  • Quality 4.0/5.0
  • Value 4.0/5.0
  • Ease of fitting 4.0/5.0

  By scottie - glasgow - Fix-It Expert

  The belts are better quality than elsewhere,i have bought several times now and don't suppose I will shop elsewhere now

• good value

  14 April 2013
  • Overall Rating 5.0/5.0
  • Quality 5.0/5.0
  • Value 5.0/5.0
  • Ease of fitting 5.0/5.0

  By holly - kent - Fix-It Beginner

  very good value for your money easy to fit last longer too quick delivery too

Ask & Answer

(1 Question & 3 Answers)

• Q How to fit to Electrolux Cyclone Power Plus 3 Answers

  Hi, bought extra belts several years ago and still have a spare. However, can't find manual and can't figure out how to open the bottom of the upright vacuum to get to the belts. Any help would be helpful. Electrolux Cyclone Power Plus - Model is Z4684 and you don't seem to have a manual for this model. Thanks in advance, sy

  by sygirl - 07 August 2009

  • A

    I used the ZE090 belt for my Electrolux (not sure of the model number but it is green colour and has a circular handle at the top) There are 3/4 screws on the top side NOT at the bottom. If you see them try to open those. The top lifts off easily. The belt was exceptional tight. I had to stretch it a lot to fit.

    by malkit - 27 April 2010

  • A

    Not sure if this helps. Stand the machine up as normal. Are there holes in the top of the part that houses the brush and belt. May be filled with dirt or fluff. If there are then it is likely that one each side will have a screw in that holds the top to the machine. removal will give access to the belt and brush.

    by Dog9Bark - 14 April 2010

  • A

    There should only be the top cover above the brushes and there is two Philips screws that hold it in place, one on the right and one on the left looking at the vac from the front. Remove the screws and the top cover should lift away lifting from the front first, the belt is then accesible.

    by ajf137 - 26 August 2009