A: Nearly made the same mistake. Inside there is a small rubber O ring, luckily I saw it when it fell out but could easily have missed it.

3 months, 3 weeks ago | by wheltonpat - Alicante, Spain

A: Yes. It is a standard size, Though I cannot remeber the actual size.

3 months, 3 weeks ago | by senna1 - Leeds

A: Hi Bob, You need the small 'O' ring which is about the same size as the one on a male garden hose connector. It just sits on the inner pipe. The screw fitting is not actually used with this connector and (I think) was or is for a different machine using the same pump. The big orange DIY store does a pack of 'O' rings in the plumbing section for about £1.99. The one you need is in there - so is the larger one for the Inlet (clear plastic) pipe. That one sits in a groove and is easy to see! Best of luck, CJ

2 months, 3 weeks ago | by CockneyJock - Trowbridge, Wiltshire

A: The O ring fits inside the female connection of the pump so that it buts up to the elbow outlet fitting.

3 months ago | by slopekeys - penkridge

A: Hi Ickp2 In order to find the right gasket for your pressure washer I will need your specific model number. For help finding your model number, refer to our handy Finding Model Numbers guide here: http://www.espares.co.uk/findingmodelnumbers.aspx

1 year, 8 months, 1 week ago | by Rory - eSpares

A: Hi Tantro, the gasket for this connection is this one: http://www.espares.co.uk/part/pressure-washers/karcher/p/1315/877/0/0/538186/karcher-pressure-washer-g.html?ms=6.362-151.0

1 year, 5 months, 2 weeks ago | by Rory - eSpares

A: yes pull the pin and remove but dont loose the o ring

1 year, 2 months, 4 weeks ago | by dibblestick